Fiber Technician

Role: Fiber Technician

Location: KANSAS CITY, MO (Onsite role)

Cabling & Termination

The Fiber Technician will mount and install racks, patch panels, fiber optic and hardware. Install grounding for racks, equipment and cable as required.

The Fiber Technician performs testing: continuity test horizontal and riser cable; use of volt-ohmmeter; troubleshoot opens, crosses, shorts, and transpose pairs on horizontal and riser cable; use a tone set.

The Fiber Technician installs LC, SC, ST, FC, FDDI, SMA and MPO/MTP connectors, for both multi-mode & single-mode fiber

The Fiber Technician will terminate simplex & duplex jumper cord

The Fiber Technician will terminate & breakout outside plant fiber

The Fiber Technician will terminate indoor tight buffered multimode and single-mode fiber

The Fiber Technician will install fan out kits including buffer tube

The Fiber Technician will calculate end to end loss budgets in accordance with TIA/EIA standards for multimode & single-mode fiber

The Fiber Technician will fully complete all paperwork accurately and on time specifically: timesheets, material transfers, work orders, change orders, tool transfers and others as required

The Fiber Technician will complete any other duties as assigned

Able to provide onsite support after business hours as part of on-call schedule.

Able to travel to various sites as needed.

Testing

The Fiber Technician will test using an OTDR, Fluke & EFXO

The Fiber Technician troubleshoots using an OTDR to identify and correct problems end to end, and Network wide

Splicing

The Fiber Technician will perform mechanical splicing with all types of fiber cable

The Fiber Technician will perform fusion splicing with all types of fiber cable

The Fiber Technician performs building entrance splices, maintenance space, and direct buried splices

Must be proficient at terminating all connector types and methods for SMF and MMF systems (Unicam, anaerobic, heat-cure)

Must have Testing & Troubleshooting MMF & SMF systems experience (OTDR & PMLS)

Prefer 3-5 years of experience in Fiber

Prefer Industry Certifications (Corning/FOA/BICSI)

Prefer Data Center installation experience

Prefer Mechanical and Fusion Splice experience

Prefer OSP / Confined Space Entry experience (splicing)

Must be able to use the following trade Tools: Screwdriver (regular and Phillips), torpedo level, tape measure, snips (with belt sheath), pliers (needle nose and channel locks), hammer, wrench set, cable stripper, flashlight and gloves. Punch tool with 110 block and 66 block blades, tone set, 6/8 position combo crimp tool, and Krone/3M/BIX.