Test & Evaluation Engineer 2

This posting is for a contract assignment and is not a full-time employment offer with Boeing. Candidates selected for roles will be employed as contract workers through a Boeing approved 3rd party for the duration of the specified project.

Assists in demonstrating the effectiveness of test methods. Develops simple test procedures, and instrumentation and configuration definition needed to perform the test and minimize risk. Designs component and sub-assembly level hardware or software and uses analytical tools to verify the design. Assists in coordinating the manufacture and assembly of test hardware. Identifies solutions to basic problems and supports the development of metrology processes, methods, and tools. Supports development of test debrief material. Participates in evaluation of test performance data. Reviews test data for accuracy, quality and/or fidelity prior to delivery to customer. Alerts senior engineers of off-nominal data. Prepares test reports for review. Works under general supervision.

Responsibilities:
Document all engineering solutions and design
Develop test plans and test procedures
Development and present technical design reviews
Works cross-functionally to support program/project plan and integrate with key stakeholders.
Applies lessons learned to the improvement of test procedures
Support development and approval of Estimates/Proposals

Required Qualifications:
B.S. Electrical Engineer, Computer Science, or equivalent
2 years electrical design
Knowledge with common drafting tools: MS Visio, Zuken
Knowledge of instrumentation sensors, and data acquisition system.

Preferred Qualifications:
M.S. Electrical Engineering or equivalent
Understanding electromagnetic interference
Wire installation
Wire design
Analyze measurement data
PLC and close-loop control
Basic knowledge of hydraulic
System engineering
Familiar with LabVIEW and NI hardware.